One of the best things you can do for your car audio system is properly the melody. There are many variables to consider when doing this and I walk through the key, so you have a good understanding of how to get more "bang" for the dollar out of your system.
Assuming you have a system with one or more amplified subwoofer, which is made in your system to give you the best sound and durability you want from her. It starts at the topUnits. You want a unit with a good strong signal output 4 to 5 volts for the pre-outs. Audiophile tell us that 2-3 volts good clean signal is good, but this is the power amplifier a little 'need to get the decibels we're looking for. They also want a head unit with an adjustable subwoofer level. Start with tuning the stereo without subtitles. Add your bass and treble until you hear the desired sound with minimal distortion at full volume, you getto it. This volume is usually about 2 / 3 max.
When you are satisfied with the sound of low / medium / high or multi-range, we can add to the U-boat. If applicable, amplifiers, tune the outputs under the 2 / 3 maximum, and head. Start the amplifier and adjust the frequency and level to a minimum, and raise the volume until the loudest point in the same, we were with the previous work. Pull the frequency to about half way, and slowly adjust the power. If you press the area you wantstay there. Remember, this is a safe technique with a speaker system that corresponds to the power amplifier. If you want more from your system to gradually adjust the frequency slightly with the increase in performance.
Their goal is a strong, clear bass of the subwoofer, the clip is in no condition stronger than you expect to get. If the amp clips out, and then set the power level lower until it is back in the safe zone. Once the system is setwhere you do not want to mess with it. Let the values of the main unit and the amplifier alone. The error I see with blown speakers and amplifiers have tried to show with all levels maxed out. This creates a lot of energy at a high level of distortion of the speakers and the amplifier is bad. If you have a louder sound than you have from his system to adjust the way you want, it might be time for an update.
Keep these guidelines when you configure the system and should beable, a car radio that are good and have a long life to build. Good luck and stay tuned!
0 comments:
Post a Comment